![H-Germany HEYNER Capsula MultiFix ERGO 3D Скачать руководство пользователя страница 16](http://html1.mh-extra.com/html/h-germany/heyner-capsula-multifix-ergo-3d/heyner-capsula-multifix-ergo-3d_instruction-manual_3071988016.webp)
English
English
GB
27
28
Because by securing the child with the three-point belt, especially in a
frontal crash, it is advantageous if the seat can move forward a little.
This prevents the child from slipping off the seat and the lap belt can-
not get into the abdominal area.
HEYNER®
recommends the use of the lap pad in group 2/3. In case of a
frontal crash, the abdomen of the child is extra protected.
Depending on the size of your child now run the shoulder belt of the car
through the appropriate belt guide slot G II or GIII. To ensure optimum belt run, the shoulder
belt should run in the middle of the shoulder.
Now run the lap belt (
W
) with buckle tongue (
V
) through the belt guide
hole (
J
) and click the buckle tongue (
V
) from three-point belt of the car
into the three-point belt buckle with an audible
<< click >>
.
Please make sure that the belt is not twisted! Make sure the belt follows
the red markings.
IMPORTANT
: Make sure that the belt of the three-point belt is not twis-
ted or jammed. Please follow strictly the drawings and installation
instructions. If you have any questions, please contact your dealer,
the importer or the manufacturer.
IMPORTANT
:
The diagonal belt should be centred over the child‘s shoulder,
the lap belt should run as low as possible over the groin.
Make sure that the diagonal strap is straight and not too close to the
child‘s neck. All straps must be tight against the child‘s body and must
not be twisted. Between the straps and the body of the child may only
fi t a fl at hand.
from the bottom to the top out of the seat part. Place the central adjusting
belt (
G5
) below the positioning cover (
F
).
Now clap back the seat part (
ST
) and put the safety bolt (
SB
) sideways into
the base holes (
BL
). Finally lock the safety bar (
SR
) of the safety bolt (
SB
) at
the top of the back of the base (
BT
).
Caution
: the safety bolt (
SB
) has to lock the seat part (
ST
) completely again
with the base (
BT
).
2.3 Installation / Fixing
The ISOFIX device is only permitted as an additional
fi xing in G II and G III. You can attach the seat with
ISOFIX (
I
) to avoid that the seat slips.
Please follow the points in section 1.3.
ATTENTION
: Please check in your vehicle hand book
which car seats are suitable and are approved.
The seat can be used on all passenger and rear seats
of the car which are equipped with a three-point belt.
But the seat must not be used on the rear center
seat only with a lap belt!
CAUTION
:
To use the
HEYNER® Capsula MultiFix ERGO 3D /
HEYNER® Capsula MultiFix AERO
as Group II + III
seat, the Top Tether (
TT
) must NOT be used!
1
2 3 4
Содержание HEYNER Capsula MultiFix ERGO 3D
