GYS Toparc SAM-1A, Руководство пользователя, Страница: 28 / 36

28
SAM-1A
EN
APPENDIX 1 - SAM-1A SETTINGS USING THE NEOPULSE/PULSEMIG
1. NEOPULSE/PULSEMIG digital inputs/outputs
.....................................................................................................
28
a) Digital inputs .....................................................................................................................................................................28
b) Digital outputs ...................................................................................................................................................................28
2. NEOPULSE/PULSEMIG analogue inputs/outputs
...............................................................................................
28
a) Analogue outputs ...............................................................................................................................................................28
b) Analogue input functions ....................................................................................................................................................29
I. JOB mode - Without settings ........................................................................................................................................29
II. JOB mode - Current settings ........................................................................................................................................29
III. JOB mode - Wire-speed settings ...................................................................................................................................30
IV. Manual Mode ..............................................................................................................................................................30
3. Where to find the JOB number
....................................................................................................................................
31
4. Where to find the synergy values
..............................................................................................................................
31
5. How to change the management mode to find the min./max. setting values
......................................
31
1. Digital inputs/outputs for NEOPULSE/PULSEMIG machines
a) Digital inputs
The SAM-1A has four digital inputs as detailed below:
Status
Pin
Connector
0 1
MMI_LOCK X20-18 Current-Voltage multimeter mode Accessing the power source settings
Start_Process X20-19 Stopping the welding process Starting the welding cycle
Start_Gaz X20-20 GAS solenoid valve closed GAS solenoid valve open
Wire_Feed
(only in MIG)
X20-16 Wire stopped Unwinding the wire
b) Digital outputs
As well as the following four digital outputs:
Status
Pin
Connector
0 1
Error X20-6 No error Error detected
Authorised_Start X20-7 Welding prohibited Welding permitted
Arc_Detect X20-14 Arc not detected Arc detected
Welding_Process X20-8 No welding in progress Welding in progress
Main_Current X20-13 Outside the main welding phase In the main welding phase
2. NEOPULSE/PULSEMIG analogue inputs/outputs
a) Analogue outputs
The SAM-1A has two analogue outputs providing voltage- and current-measurement information
as follows:
Voltage measurement (M_Weld_Voltage, X20-5): varies from 0 - 10 V and covers a measurement range of 0 - 50 V.
Current measurement (M_Weld_Current, X20-15): varies from 0 - 10 V and covers a measurement range of 0 - 500 A.