GYS EASYMIG 85, Руководство пользователя

Страница: 15 / 72

15
EASYMIG 85
EN
TROUBLESHOOTING
OPERATIONAL ISSUES POSSIBLE CAUSES SOLUTIONS
The flow rate of the welding wire is not
constant.
Spatter is obstructing the opening.
Clean or replace the contact tube and re-ap-
ply the anti-sticking agent (ref. 041806).
The wire is slipping on the rollers.
• Check the rollers’ pressure or replace
them.
• Wire diameter does not match that of the
roller.
• Wire-guide sheath in the torch not suitable
for use.
The unwinding mechanism is not wor-
king.
The spool’s brake or roller is too tight. Release the brake and the rollers.
Power supply problem.
Check that the start button is in the ON
position.
Incorrect unwinding of the wire.
Dirty or damaged wire-guide sheath. Clean or replace.
Pressure roller not tight enough. Further tighten the roller.
Spool's brake is too tight. Release the brake.
No welding current.
Incorrect mains outlet connection.
Check the socket's connection and verify
that the socket is supplied with 230 V (1PH).
Poor earth connection.
Check the earth wire (the condition of the
clamp).
Power switch not working. Check the torch's trigger.
The wire gets jammed after passing
through the rollers.
Compressed wire-guide sheath.
Check the wire-guide sheath and body of
the torch.
Wire blockage in the torch. Replace or clean.
No capillary tube. Check that the capillary tube is present.
Wire speed too high. Reduce the wire speed.
The weld bead is porous.
Air circulation or wind influence.
Avoid draughts and protect the welding
area.
Gas nozzle is too clogged. Clean or replace the gas nozzle.
Bad wire quality. Use a wire suitable for NO GAS welding
Poor quality of the welding surface
(rust, etc.).
Clean the part before welding.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported.