GYS CUTTER 70 CT, Руководство пользователя

Страница: 22 / 67

22
CUTTER 70 CT
EN
False temperature information
The temperature sensor is damaged or
disconnected
Check sensors connections, replace
them if necessary
No current established
There is no contact between the elec-
trode and the tip
Check that the consumables are in
place and in a good shape. Replace
them if necessary. Restart the machine
and try again.
Power relay fault. The power relay does not closed. Return the product for repair
- Arc stops after 3 seconds of cutting No current detection in the earth clamp
Check that the earth clamp is connec -
ted to the cutting part on a clean area
(no rust, paint or grease).
- The machine does not switch on. No power supply
Check that the power cord of the pro -
duct is plugged into the outlet and that
the power switch is in the on position.
Check that the circuit-breaker has not
tripped.
- The pilot-arc cuts out too quickly Used consumables
Check the condition of the consumables
and replace if necessary.
- The arc stops mid-way through cutting
cutting speed too low on thin sheets
Reduce the current / increase the
movement speed.
Contact on the low-quality earth clamp
Check that the earth clamp is connec -
ted to the cutting part on a clean area
(no rust, paint or grease).
Cutting height too high
Use a cutting pad and keep it in contact
with the part to be cut.
- Premature wear of consumables
Cutting current inappropriate for consu-
mables used
Refer to the chapter "Setting the cut -
ting current".
Inappropriate air pressure
Refer to the chapter "Adjusting the air
pressure".
Humid air
Purge the air filters from the station
and the compressed air network. Add
the additionnal Air filter ref. 039728.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported