EN
15
Operating manual
GYSDUST EXTRACTOR
Translation of the original
instructions
5 - Insert the duct into hole 1.
6 - Connect suction hose 2 and sander supply 3 (G1/4)
7 - Connect coupler 4 to the hoover.
1
4
2&3
FAILURES AND ANOMALIES
Failures
Anomalies
The hoover does not
work
Check that the hoover is connected to the compressed
air network.
Press the start button.
Check the pressure gauge inside the hoover.
It is set at the factory and should be at 3.5 bar.
Check that no hoses are pinched or disconnected.
Check that the bag or the duct is not blocked.
The sander does not
work
Check that the pneumatic hose is connected.
Check that the pressure gauge 1 indicates a pressure
of around 4 bar, otherwise adjust using the knob.
2
1
CLEANING OF DUST DEPOSITS
At the end of the working day, check for dust deposits on the flat surfaces of the hoover (front, top, etc.). If there are
dust deposits, make sure that the metal clamp of the hoover is connected to the earth circuit of the installation and
carefully remove the dust deposits, avoiding creating explosive atmospheres.
