GYS 069244, Руководство по эксплуатации

Страница: 16 / 60

16
Operating manual
DRAW ALIGNER PRO
Translation of the original
instructions
SAFETY WHEN USING AND MOVING
Be aware of the risks when using the PRO PULLING BRACKET. Before beginning to pull, always check the
stability of the PRO PULLING BRACKET. If you are using the support arms, make sure they are firmly in place
against the underbody or wheel. With the plate under the wheel, ensure that the vehicle rests correctly on the
plate. Never stand behind the chain when it is under tension. If it comes off, there is a high risk of injury.
This drawing bracket is intended to be used for straightening cladding plates. This bracket must not be used on structural components
(sleeper blocks, B pillars, lower-body reinforcements), as these elements are made of high-strength, high-tensile steel and require a
very high pulling force. Any damage to the product resulting from use that does not follow these recommendations will not be covered
by the warranty.
Do not operate the pump on the pump stand as this may cause the pump to be deflated.
Always place the pump on the ground when in use.
Do not stand behind the drawbar when it is in operation. Risk of serious injury.
MAINTENANCE
In order for the product to work at its best, it is important to perform regular maintenance according to the instructions below. The
frequently that maintenance is carried out is based on normal use and a daily usage of eight hours. For more intensive use, the
maintenance should be carried out more frequently.
- Check the condition of the chain and the pulling claw,
- Check the parts for possible cracks or wear,
- Check that the bolts are tight,
- Check the pump hose for damage,
- Check the oil level and top up if necessary,
- Check the tightness of the hydraulic connections.
MAINTENANCE
Dusting can be done with an air gun before cleaning. Wash the PRO PULLING BRACKET with a product suitable for painted, steel
surfaces. Follow the cleaning product’s instructions. After cleaning, wipe the PRO PULLING BRACKET with a cloth. Never use a
high-pressure sprayer as this can damage the paint.
TROUBLESHOOTING
Providing that the maintenance instructions have been followed, the PRO PULLING BRACKET is designed for safe and effective
useage. However, if you do encounter any operating problems, here is some advice. If problems persist, contact the repairer or the
manufacturer.
If the PRO PULLING BRACKET’s arm does not move when you operate the hand pump:
- Check that the pump’s control knob is fully tightened,
- Check that there is enough oil in the pump,
- Check that the pump is correctly connected to the jack cylinder.
TECHNICAL FEATURES
Product weight when empty 53 kg
Pulling capacity 1.2 T
Height of product 123 cm
Width of product 39 cm / 116 cm
Depth of product 116.5 cm / 165.6 cm
Storage temperature 0°C to 60°C
Operating temperature 5°C to 50°C