3
1.
Insert 3 AAA batteries into battery clip.
2.
Attach battery clip to mouse by snapping into place.
Setting Up and Synchronizing Ultra Mouse and the
Receiver:
1.
Make sure the mouse is fully charged.
2.
Power on your computer and connect the Receiver’s USB cable into
an available USB port on your computer. Follow standard USB
device installation screens.
3.
Press and hold the LEARN button on the Receiver for 2 seconds. The
STATUS light will blink slowly, indicating that the receiver is in
“Learn Mode.”
4.
Press the TEACH button located on bottom of the mouse handset.
The status light on the Receiver will blink rapidly for 4 seconds, then
will blink slowly. Push the TEACH button on any additional devices
(
i.e.
keyboard or 2
nd
mouse) at this time.
5.
OPTIONAL: To exit “Learn Mode,” press the LEARN button on the
Receiver for 2 seconds. Otherwise, after five minutes, Learn Mode
will automatically time out.
If more than one Gyration device is being installed on the system, place the
Receiver into Learn Mode (step 3 above) only once, then “Teach” each device
before exiting Learn Mode. Do not push the Learn button on the receiver for
each device to be added. (Also see “Installing 3 or More Devices” on page 9.)
When the Receiver is put into Learn Mode, it erases its memory of learned
devices and looks for new devices. Therefore, when adding a new device to a
system it is necessary to put the Receiver into Learn Mode then Teach all
devices that will be used on the system.
Note:
After the Teach/Learn sequence is performed, the Receiver and the device will
remain synchronized after powering down and changing channels. It is only necessary
to perform the Teach/Learn sequence when setting a device up for the first time or
when adding additional devices to the system.
