Gymstick FTR7 INDOOR RACER, Руководство пользователя

Страница: 12 / 16

12 FTR7 INDOOR RACER
OPERATION
INSTALL BATTERY
When installing the battery, the screen will display as following (drawing on left) and have “Bi” sound at the
same time. After that, it goes to the next step to the main menu as (drawing on right)
OPERATION PROCEDURE
When you are in each set-up mode, for example in the time set-up mode, time value is blinking, you can
press “SET” button to adjust the value and press “MODE” for confirmation.
With any signal been transmitted into the monitor, the value of TIME, DISTANCE, CALORIES start to count
up. When there is any function has been preset the target (TIME or DISTANCE or CALORIES), the function
will be counting down from the preset to zero while the training starts. Once the target is achieved to zero,
the monitor start to beep for 8 seconds, and the function will be counting up from zero directly if the training
is going on. Press “MODE” button for confirmation and skip to next set-up.
You can also press “MODE” button to select single function display, except RPM & SPEED function. The
RPM & SPEED function will switch display.
NOTE
1. Stop training for 4 minutes, the computer will enter sleep mode. Press any button to have the computer
restart working, the original value will retain. (if re-install batteries, the original value will be erased)
2. If the computer displays abnormally, please re-install battery and try again.
HOW TO REPLACE THE BATTERY
1. Hold up the clip on the battery cover and
remove the battery cover.
2. Remove the old battery and install a new
CR2032 (3V) battery by tilting the battery
slightly to its side and slide it in.
Note: positive (+) at upper side and negative (-)
at down side.
3. For the battery change, please gently press
the clip on the side and the battery will pup up.
4. Place the battery cover back.