Gyms GymSilky HWP-333SL, Инструкция по эксплуатации

Страница: 21 / 28

21
English
Safety precautions
When carrying the product filled with water in, make
sure the cap and the bottle screws are tightly closed
and lock the cap.
If they are not closed tightly or the cap is not locked, water
may leak due to some reasons (such as the button on the
cap being pressed with the baggage in the bag).
When carrying the product filled with water in a bag, do
not place it sideways.
If the power is turned on with the product lying down, water
may leak from the pressure reducing valve on the cap.
Do not drop the product or subject it to strong shock.
Otherwise, it could result in deformation or damage of the product.
Do not freeze the product.
Otherwise, it may cause the product to fail or damage.
Do not charge the product with any AC adapters other
than the attached one.
Otherwise, it may cause the product to fail.
When inserting or pulling out the USB cord, be sure to
hold the connector.
Otherwise, it could result in damage or short circuit of the
USB code and a failure of the product.
Do not use the product under water or splash seawater
or hot spring water on it.
This product is water-resistant. However, do not use the
product under water. Furthermore, be careful not to spray
any water other than fresh water on the product.
Otherwise, it may cause the product to fail.
Use normal water or hot water only.
The use of liquid other than water may cause stain, coloring, smell
of the bottle and the electrode plate or failure of the product.
Be sure to clean the inside of the bottle of the product
and the ceramic particle cartridge before using for the
first time. (
l
page 23)
When the ceramic particle cartridge is replaced, clean
the new one before using. (
l
page 23)
When cleaning the inside of the bottle of the product,
remove the ceramic particle cartridge and clean it with
neutral detergent and soft sponge. (
l
page 26)
Do not use abrasives or metal brushes.
Clean the inside of the product and the ceramic particle
cartridge daily.
Do not apply hot water (above 70 ° C) to the cap and the
electrode plate and sterilize them by boiling.
There is the risk of paint peeling.
Do not soak the base generator in water.
Wipe off the moisture of the base generator well.
Otherwise, it could result in failure of the product.
When using the ceramic particle cartridge,
recommended water quantity is 330cc or less.
If you put too much water, it may overflow when the cap is
closed.
However, if the amount of water is too little to reach the
ceramic particle cartridge, chlorine odor may not remove.
Do not attempt to disassemble or alter the base
generator by yourself.
Otherwise, there is a risk of electric shock, short circuit, or fire.
It is not covered by the warranty.
A person with a pacemaker or any other internal device
should not drink during the hydrogen generation.
The weak current in the water during hydrogen generation
may affect a function of the internal device.
A person whose water intake is restricted should
consult with a doctor before drinking.
It may affect your physical condition.
Drink the generated hydrogen water immediately
without keeping it.
Otherwise, there is a risk of food poisoning.
Keep the product out of reach of infants.
It may cause accidental ingestion of parts or trouble.
When using hot water, wear gloves or use a dry cloth to
prevent scald.
The product may be hot and cause scald.
When using hot water, check the temperature before
drinking.
It may cause scald if you drink directly.
Try to drink hot water after pouring into another vessel.
When using hot water, keep the water level below the
bottle screw. (
l
page 25)
Hot water may spout and cause scald.