Gyms GymSilky HWP-333SL, Инструкция по эксплуатации

Страница: 25 / 28

25
English
Notice
. ●
If the LED turns off during generation (before the specified time), the remaining battery capacity is low.
Try to generate the water again after charging for more than 15 minutes.
. ●
It is possible to generate water while charging. When the battery is fully charged, it is possible to generate hydrogen water (3
minutes mode) approximately 10 times continuously.
(The number of generation times depends on the water quality and the state of charge.)
. ●
Bacteria tend to increase faster in hydrogen water than in tap water.
Do not drink the generated hydrogen water that has been left for a long time.
. ●
Hydrogen is easier to escape as the water temperature, air temperature or room temperature increases.
It is recommended to generate the hydrogen water left in the product again after time passed for a while to increase the hydrogen
concentration.
. ●
Hydrogen concentration of generated hydrogen water varies depending on the water quality.
. ●
Remove the ceramic particle cartridge from the cap and dry it after use. Humidity of the ceramic particle cartridge may promote the
growth of mold and the function of the ceramic particle deteriorates quickly.
. ●
Water that is difficult to conduct electricity, such as pure water or RO water, does not increase the hydrogen concentration.
■ When using hot water
Be sure to keep the water level below the bottle screw. (right illustration: below the red line)
. ●
Since the temperature of the bottle gets high, wear gloves or use a dry cloth to prevent scald.
. ●
It may cause scald if you drink directly. Try to drink hot water after pouring into another vessel and
check the temperature of water.
. ●
Remove the ceramic particle cartridge before use.
Generate hydrogen water
1
Open the cap, fill the bottle with water and close the cap.
When the ceramic particle cartridge is installed : Water volume is 330cc or less
When the ceramic particle cartridge is not installed : Water volume is 350cc or less
. ●
When using hot water or mineral water, remove the ceramic particle cartridge.
. ●
When using hot water
l
see below
2
Press the generation button twice (within 2 seconds) or three times (within 3
seconds) continuously.
Twice continuation : 1 minute mode
3 times continuation : 3 minutes mode
. ●
If you do not press the number of times in succession, the power will not turn on and generation
will not start.
3
After the LED flickers, it will light up and generation will start after about 5
seconds.
1 minute mode : Blue light flash up once ⇒ Blue lights up
3 minutes mode : Blue light flash up 2 times ⇒ Blue lights up
. ●
When you want to stop generation, press the generation button.
4
When generation is completed, the LED turns off.