Starting Your Installation
Preparation
Check the following list of components to ensure that all
parts are packed with your system.
1 - Storage Tank
1 - RO System
1 - Faucet
1 - Installation Kit
Determine the location for the installation of the RO
system. Avoid locations where the system might come
in contact with hot water pipes or other hazards.
Determine the location for the faucet. Check to see that
drilling the faucet hole will not damage pipes or wires
running underneath the sink.
Fittings and Tubing
Compression fittings are used throughout the system.
To insure a optimal seal, tubing should be cut with the end
square. An angled cut or distortion of the tubing will not
provide an efficient seal and may cause leaks.
To Install a tube, push in the collet until it seats firmly. To
remove a tube, push in the collet and pull out the tube.
Determine the location for the storage tank. A maximum
distance from tank to faucet of 15 feet is possible. The
system will produce a faster flow at the faucet with the
shortest tubing run from tank to faucet.
