GVA DD1-10, Инструкция по эксплуатации

Страница: 7 / 16

2
Getting Started
Before first use
• Unpack the appliance but keep all packaging materials until you have made sure your new
bar fr eezer is undamaged and in good working order.
• Plastic wrapping can be a suffocation hazard for babies and young children, so ensure all
packaging materials are out of their reach.
• Check to ensure you have all the parts listed on the opposite page, plus an instruction
manual and a warranty certificate.
• Read this manual to familiarise yourself with all the parts. Pay particular attention to the
safety instructions on the previous pages.
• Unwind the cord to its full length and inspect it for damage. Do not use the appliance if
the appliance or its cord have been damaged. In case of damage, contact our after sales
support line for advice on examination, repair or return of the damaged product.
• Make sure the bar fr eezer is disconnected from the power supply before cleaning the
interior surfaces with lukewarm water using a soft cloth to remove any dust from transit
and storage. Dry the appliance thoroughly.
• Your bar fr eezer has the capability of the door opening from the right or left side. If
your setup requires reversal of the door swing, follow the instructions on page 5 .
• Your new bar fr eezer is now ready for use – see page 4 for instructions.
Installing the bar fr eezer
• Before installing your new upright bar fr eezer , read all safety instructions in this manual,
especially the sections on electrical safety and installatio n . Then follow the
instructions below.
• This appliance is designed to be freestanding only and should not be recessed or built in.
• Place the bar fr
eezer on a sturdy, level floor that is strong enough to support the unit when
it is fully loaded.
• DO NOT install the appliance directly on carpeting or soft material. Carpeting must be
removed or protected by a metal or wood panel beneath the appliance, which extends at
least the full width and depth of the appliance. NOTE: Ensure that the appliance does not
stand on the electrical supply cable. Parts which heat up should not be exposed. Whenever
possible, the back of the appliance should be close to a wall but leaving the required
distance for ventilation.
Overloading the fr eez e r will affect cold air circulation and cooling performance. We
therefore recommend you only load the fr eezer up to about 70% of its storage volume,
always leave some space around food stored, and do not use containers that are too
large and block ventilation openings.