4
5 Installation
To install the hood perform the following operations:
1. mount the hood body [C],
2. connect the hood to power supply network.
1. Installation of the hood body
a) trace a vertical line on the wall to indicate the center of the cooker plate, dismantle the
grease filter, hold the hood body „A” to the wall with its indicated center point on the
vertical line, with the distance between the holes and the cooker plate at least 710 mm
(Fig.2).
Note: make sure that the hood body „A” is level.
Fig. 3
b) mark the locations of fixing holes on the wall
c) drill the holes as marked on the wall, using drills of diameter corresponding to the
attached expansion plugs, drive the plugs in and then screw the hood body „A” to the
wall (rys 3).
2. Connecting to the power network and operation check
After connecting the device to the power supply network (in accordance with the
requirements defined above) it is necessary to check operation of the motor and lighting of
the hood.
3. ASetting the operation mode of the kitchen extractor hood
3.1 Setting the air extractor mode of operation of the hood
In the extractor mode air is discharged to the outside by a special conduit. In that setting
any carbon filters shall be removed. The hood should be connected to the opening
discharging air to the outside by means of a rigid or flexible conduit of 120 mm diameter,
which should be purchased in a shop selling installation materials.
A qualified installer should be commissioned to make the connection.
Содержание ZRW
Страница 16: ......