8
Press
for 3 seconds to power on/off the unit.
Press
to change the temperature display between °C and °F.
Press
to turn on or off the lights.
Without touching any button for 15 seconds, the touch screen will be locked
automatically.
p
Setting The Temperature Controls
• When press the temperature setting button “﹢” or “-“, the system will enter the set up
mode of the upper or lower compartment automatically. The LED display will flash
and show the setting temperature. After 5 seconds the flash will stop and it will show
the actual measured interior temperature.
• Press the button once, the temperature will decrease or increase 1°C. After stopping
pressing the button for 5 seconds, LED figure will stop flash, then revert back to
display the setting temperature of the upper or lower compartment.
• After the unit is unplugged, the system will return to default setting temperature,
which set by factory. The default setting temperature as below:
• Upper compartment: 6°C
• Lower compartment: 12°C
•
Upper compartment:
The temperature setting can be adjusted from 5°C to 12°C.
•
Lower compartment:
The temperature setting can be adjusted from 12°C to 20°C.
Attention
• If the unit is unplugged, power lost, or turned off, you must wait 3 to5 minutes
before restart the unit. If you need attempt to restart before this time delay, the Wine
Cooler will not start. If first time use or longer absence of using, the temperature will
difference between setting and LED display temperature. After running a period, the
temperature will be reverting back.
p
Shelves
• To prevent damaging the door gasket, make sure to have the door all the way
opened when pulling shelves out of the rail compartment.
• For easy access to the storage content, you must pull the shelves approximately 1/3
out of the rail compartment, however this unit was designed with a notch on each
sides of the shelf tracks to prevent bottles from falling.
Please refer to the following direction for replace shelf with different method.