11
3. When ice maker harvest,symbol<
> flash, the water will flow from top water
reservoir to bottom water tank through solenoid valve, the symbol <
> will be on,
when the water in the bottom water tank is full, the symbol <
> will be off, then
the next ice making cycle start again. When there is no water in the water reservoir,
the symbol <
> will keep on. Turn off the unit and fill water again, then restart the
unit to make ice cube. Or fill water directly and wait 20 mins, the unit will restart.
Remark:
The ice making cycle lasts about 13 to 25 minutes, depending on
the ambient temperature. And for the first time, according to the initial water
temperature, ice-making last time will be a little longer. In the extreme hot room
temperature, ice-making time may be Vary a lot, but it will not exceed 35 minutes.
If you think the ice cube is not thick enough, during ice making,press the <+> and
<-> to set the ice making lead time. Press one time and the ice making cycle will in
crease or Reduce one min, 6 min most. This can only start from the new cycle.
4. When Ice Full symbol <
> is on, the unit will stop, take out the ice cube inside, the
unit will start working again.
If press the button <ON/OFF> more than 5s,when the ice maker is working, the unit
will start harvest. Press button <ON/OFF>, the unit will turn off.
Timer setting. Unit on timer setting. When the unit is working,timer setting the unit
off.
Timer setting. When the unit is off,timer the unit on.
Press the <TIMER> button,the display will show <1H>, and then press <+> and <->
to set the time. During the setting,the H is flash,after 5s, the H will keep on and unit
will in your Timer setting.
5. Water Drain: take off the Water draining cap the bottom of unit ,then drain the
water inside. It is better that exchange water every 24 hours and clean unit every 3
days.
AUTOMATIC SELF-CLEANING PROGRAM
Start the self-cleaning program:
Plug on the unit, press “TIMER/CLEAN” button on
control panel for more than 5 seconds, to enter the self-Cleaning program need 20
minutes. The symbol
rotate on display screens, time count down area display 20M.
Cancel the self-cleaning program:
It takes about 20 minutes to complete one
self-cleaning program. When the program is over, the system will be in off-state
automatically. And also you can press the “ON/OFF” button on control panel to cancel
the self-cleaning program by force.