3 Commissioning
This chapter provides you with important safety notices during the initial commissioning of the device.
Observe the following notices to avoid dangers and damages:
3.1 Safety information
WARNING
Personal and property damages can occur during commissioning of the device!
Observe the following safety notices to avoid such dangers:
► Packaging materials may not be used for playing. There is a danger of suffocation.
3.2 Delivery scope and transport inspection
As a rule, the milk frother is delivered with the following components:
• Milk forther
• Whisk for frothing
• Operating Instructions
PLEASE NOTE
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete shipment or
damages as a result of inadequate packaging or due to transportation.
3.3 Unpacking
Unpack your device as follows:
• Take out the device from the box and remove the interior and exterior packaging.
• Clean the appliance thoroughly before the first use. (see chapter Cleaning and maintenance)
3.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging materials are
selected in accordance with environmentally compatible and recycling-related points of view and can
therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the quantities of
accumulated waste. Take any packaging materials that are no longer required to “Green Dot” recycling
collection points for disposal.
PLEASE NOTE
► If possible, keep the original packaging for the device for the duration of the guarantee period of
the device, in order that the device can be re-packaged properly in the event of a guarantee claim.
3.5 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must fulfil the
following prerequisites:
The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing capacity.
Choose the setup location in such a way that children cannot reach the device.
The device is not intended to be installed in a wall or a built-in cupboard.
Do not set up the device in a hot, wet or extremely damp environment or near flammable material.
The electrical socket must be easily accessible so that the power lead can be disconnected easily, in
the case of an emergency.
The installation and assembly of this device in non-stationary setup locations (e.g. on ships) must be
carried out by specialist companies / electricians, provided they guarantee the prerequisites for the
safe use of this device.
Содержание GZ-002
Страница 24: ......