Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
15
Assembly page 15/36
Fax +32 2 359 95 50
POSITIONING OF THE APPLIANCE
The heater should only be operated at a minimum distance of 50cm from any wall or other
object. Position the air flow in order to optimise the heating of the room. Avoid corners, small
volumes, floors and ceilings. Use the handle of the appliance to turn it and position the air flow.
OPERATION
When the appliance is switched on for the first time, a slight smell may be emitted. Please
ensure sufficient ventilation. This smell will disappear very quickly.
Place the power selector in "0" position, the thermostat on its minimum position and put the
plug in a 230V power socket.
The selector allows you to choose the desired power. The higher the power, the faster the
heating will be.
The thermostat regulates the temperature in the room. Turn the thermostat clockwise to
increase the ambient temperature or anticlockwise to decrease it.
When the selector is in
position, the appliance operates as a fan, but will not heat.
Power selector
0
OFF
Fan without heater
1000W
2000W
Note: before switching off the appliance, we advise you to operate it in
position for 2 to 3
minutes in order to cool it down.
OVERHEATING PROTECTION
This heater is protected with an overheating protection that switches off the appliance
automatically in case of overheating, e.g. due to the total or partial obstruction of the grids. In
this case, unplug the appliance, wait about 10 minutes for it to cool and remove the object
that is obstructing the grids. Then switch it back on as described above. The appliance should
operate normally. Should the problem persist, please contact the customer service.
CLEANING AND CARE
•
Before cleaning the appliance, ensure it is disconnected from the power supply and has
cooled down completely.
•
To avoid the risk of electric shock, do not clean the heater with water and do not immerse
it. Clean the housing with a damp cloth.
•
If necessary, dust particles accumulated in the air outlet openings may be removed with a
vacuum cleaner. This maintenance should be done regularly to assure the good
operation of the appliance.
