- 6 -
IR Remote control
* DAC-A18 uses the new remote control, please press and hold the DAC key for more
than 3 seconds to enter the DAC operation mode.
①
Mute button: In the non-mute state, press this button once, the DAC-A18 will be muted; press this button
again to unmute.
②
Menu button: Press this button once to enter the setup menu of the DAC-A18, press this button again to exit
the setting menu.
③
D-pad and OK button：After entering the setting menu of the DAC-A18, use the up/down of the D-pad to switch
the function to be adjusted, and adjust the options by left/right. Press OK to confirm the result and return
to the main page.
④
Back button: Returns to the main page state.
⑤
Volume minus button: When the DAC-A18 is in the main page state, press this button to decrease the volume.
⑥
Volume plus button: When the DAC-A18 is in the main page state, press this button to increase the volume.
Note: ● The operating distance varies depending on the angle. ● If there is something between the remote control
and the IR sensor, it may not operate normally. ● If the remote control will not be used for a long time (one
month or longer), remove the battery. ● If the battery Leaking, please thoroughly clean all the residues in the
battery compartment and install new batteries. ● When using other devices controlled by infrared rays, using
this remote control may operate these devices by mistake.
