Guldmann 12075-000, Руководство пользователя

Страница: 5 / 16

5
1 .04 . Sling .Safety
Only CE-marked slings with a lifting capacity corresponding to or higher than
the lifting capacity of the DH 000 are to be used.
The lifting straps must be suitable for hooks with a diameter of 8 mm. The lif-
ting straps must be designed for use with a four-point horizontal lifting hanger.
Guldmann cannot be rendered liable for defects and accidents, due to use of
a sling manufactured by others.
1 .05 . Unpacking .and .preparation .of .the .hoist
Visual .check .of .hoist:
Should the packaging be damaged on receipt, each part of the hoist must be
carefully examined for visible defects or deficiencies. In case of suspected
damage, do not use the hoist until authorised by qualified service staff or the
Guldmann Service Team.
Parts .list:
Pos .
1. DH 000
. Hand switch
3. Lifting hanger, if delivered
1 .06 . Mounting .of .charging .station .
Always position the charging station together with an end stop. Check that the
current receiver on the hoist / trolley for traverse rail is turned the right way so
that it faces the conductor housing.
Make a mark on the rail to indicate where
the end stop is to be positioned.
B Loosen the end stop and slide it up the rail.
Pull the wire of the conductor housing out
of the rail and position the rear end of the
conductor housing opposite the mark.
C Remove the cover film from the tape on the
conductor housing and push one side of the
conductor housing into the rail.
D Push the other side of the conductor hou-
sing into the rail so that it rests on the bot-
tom of the rail. Check that the conductor
housing is positioned opposite the mark.
E Push the conductor housing into position in
the rail. Push right at the side of the condu-
ctor housing in order to avoid deforming it.
Give the conductor housing a press to
ensure that the tape is in fully contact with
the rail.
�
�
�
E. D. C.
F.
B.
A.
�
�
� �
©
G
ul
dm
an
n
G
B
-8
96
/0
8/
08
•
#
9
00
66
©
G
ul
dm
an
n
G
B
-8
96
/0
8/
08
•
#
9
00
66