Guild PRG350G, Инструкция по эксплуатации

Страница: 11 / 16

Customer Helpline
0333 3201989
11
Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
If the supply cord is damaged, a special cord or assembly available from the manufacturer or its
service agent must replace it.
Always remember to disconnect the plug from the socket before cleaning the spray gun or paint
tank, it is essential that the spray gun is cleaned thoroughly after every use. Failure to clean it
will almost certainly result in blockages and it may not operate when you next come to use it.
WARNING! Do not clean the parts by holding the machine in flowing water. Never
clean the parts by submerging the machine in water or thinner.
The following action must be taken after every use:
1) After switch off the gun, depress the trigger switch again to return the paint remained in the
spray gun back to the tank.
2) Remove the tank and pour the remaining liquid back in to the can.
3) Clean the tank thoroughly using paint thinner.
4) Put some suitable thinner into the tank and be sprayed through the spray gun until only
clean thinner comes out of the nozzle.
5) Remove the tank, the suction tube and the filter, and thoroughly clean them.
6) Loosen the nozzle slightly, unscrew the locknut and move the nozzle from the cylinder, take
the valve out of the cylinder.
7) Clean the nozzle, valve, locknut, cylinder thoroughly with thinner.
8) Use the cleaning pin to clear the nozzle and the swirl head of the valve.
9) Reassemble the spray gun.
10) Clean the outside of the machine with a moist cloth.
CLEAN THE FILTER (SEE FIG. H1, H2):
Remove the filter cover by turning it counter-clockwise. Take the sponge filter out and clean it.
Re-install the dry and clean filter back to the tool.
WARNING! Do not use the tool without filter, otherwise dirt may be sucked in the tool.
CLEAR THE NOZZLE/AIR CUP (SEE FIG. H3)
Clear the nozzle (11) or air cup (10) with solvents or water when the nozzle/air cup is blocked
with paint or the paint is accumulated on the air cup. (SEE FIG. G3)
Clearance and Maintenance
H1 H2