Customer Helpline
0333 3201989
11
Operating Instructions
2. INSTALLING AND ADJUSTING AUXILIARY HANDLE (SEE FIG B)
An auxiliary handle is supplied and can be fixed into any of the three positions on the
gearcase. If you are right handed fit the handle as shown in B. If you are left handed fit
the handle the other way round. When using a cutting disc, you can screw the handle
into the position on top of the gearcase.
NOTE:
This handle should be used at all times to maintain complete control of the tool.
3. FITTING THE DISCS (SEE FIG C1-C3)
Put the inner flange onto the tool spindle. Ensure it is located on the two flats of spindle
(SEE FIG C1).
Place the disc (not supplied) on the tool spindle and inner flange. Ensure it is correctly
located. Fit the threaded outer flange making sure it is facing in the correct direction
for the type of disc fitted. For grinding discs, the flange is fitted with the raised portion
facing towards the disc. For cutting discs, the flange is fitted with the raised portion
facing away from the disc. (SEE FIG C2)
Press in the spindle lock button and rotate the spindle by hand until it is locked. Keeping
the lock button pressed in, tighten the outer flange with the spanner provided. (SEE FIG C3)
NOTE:
After mounting the grinder tool and before switch on, check that the grinding
tool is correctly mounted and that it can be turn freely, make sure that the grinding
tool does not graze against the protecting guard or other parts.
B
C1
C2
C3
9
Grinding disc
( not supplied)
Cutting disc
( not supplied)
10
10
9
