Customer Helpline
0333 3201989
10
NOTE:
Before using the tool, read the instruction book carefully.
Intended Use
This tool is intended for cutting, roughing and brushing metal and stone materials without
using water. For cutting metal, a special protection guard for cutting (accessory) must be
used.
1. INSTALLING AND ADJUSTING THE WHEEL GUARD (GRINDING OR CUTTING) (SEE
FIG A)
Before any work on the tool itself, remove the mains plug from socket.
For work with grinding or cutting discs, the wheel guard must be mounted.
Wheel Guard for Grinding
The coded projection on the wheel guard (5) ensures that only a guard that fits the tool
type can be mounted. Loosen the Clamp Adjusting Nut. Place the wheel guard (5) with
coded projection into the coded groove on the spindle of the tool head and rotate to the
required position (working position). Then tighten the Clamp Adjusting Nut.
Wheel Guard for Cutting
WARNING!
For cutting metal, always work with the wheel guard for cutting (not
supplied).
The wheel guard for cutting is mounted in the same manner as the wheel guard for
grinding (5).
2. INSTALLING AND ADJUSTING AUXILIARY HANDLE (SEE FIG B)
You have the option of two working positions to provide the safest and most comfortable
control of your angle grinder. The handle is screwed clockwise into either hole on the
sides of the gear case.
NOTE:
This handle should be used at all times to maintain complete control of the tool.
Operating Instructions
A
B
