Guild PFS260GH, Инструкция по эксплуатации

Страница: 8 / 16

Customer Helpline 0333 3201989
8
Operating Instructions
SANDING PAPER WITHOUT HOOK & LOOP SYSTEM (SEE FIG B , C , D)
FIT THE SANDING PAPER
Fit the sanding paper over the base. Make sure the sanding paper is even with the
edges and that the dust collection holes in the base and sanding paper is aligned and
that the sanding paper is taut on the base.
Lift the sanding paper retaining clips to the open position and insert one end of the
sanding paper under the retaining clip.
Push the clip back into the retaining position. Lightly stretch the paper over the base
plate ensuring that it is not folded or wrinkled then position under the other retaining
clip back into the retaining position. Check that the paper is flat to the base plate,
if not, release either clip and reposition the paper before resetting the clip. Switch
on momentarily to check that the sander is functioning correctly. If there is undue
vibration, repeat the paper positioning procedure.
REMOVE THE SANDING PAPER
To remove the sanding paper, lift up the clamp lever and move away from the clamp
lever lock. The sanding paper clamp is now loose. Repeat with the other clamp on the
opposite side of your sander.
B C
D C3