Customer Helpline 0333 3201989
7
NOTE: NOTE: Before using the tool, read the instruction book carefully.
Intended Use
This tool is intended for impact drilling in brick, concrete and stone as well as for
drilling in wood, metal and plastic.
1. AUXILIARY HANDLE (SEE FIG A1, A2)
Slide the handle onto the drill and rotate to the desired working position. Make sure that
the teeth on the grip fit into the protrusions on the handle collar. To clamp the auxiliary
handle, rotate the handgrip clockwise. To loosen the auxiliary handle, rotate the hand
grip anti-clockwise.
Always use the auxiliary handle.
WARNING! Always check and rotate the handle tightly before using to avoid any
accident.
2. INSTALLING THE DEPTH GAUGE (SEE FIG B)
The depth gauge can be used to set a constant depth to drill. To use the depth gauge,
loosen the handle by rotating the bottom section of handle anti-clockwise. Insert the
depth gauge through hole in handle. Slide the depth gauge to required depth and tighten
fully.
3. INSERTING A DRILL BIT INTO CHUCK (SEE FIG C)
WARNING: Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Remove chuck key from key storage tab at base of drill handle, then place key into
chuck, turn key anti-clockwise to undo/loosen chuck, inset drill/tool and firmly tighten
chuck by turning key clockwise. For optimal performance, tighten each point on chuck.
Remove key and replace in storage tab at base of drill handle (See Fig C).
Operating Instructions
A1
A2
