Customer Helpline 0333 3201989
11
Operating Instructions
2. REMOVE OR INSERT BATTERY PACK (SEE FIG B)
Press the battery pack release button and remove the battery pack from the tool.
After recharge slide the battery pack into tool’s battery port. A simple push and slight
pressure will be sufficient.
OPERATION
1. ON / OFF SWITCH (SEE FIG C)
Depress the On/Off switch to start and release it to stop your drill. The on/off switch
is fitted with a brake function which stops your chuck immediately when you quickly
release the switch.
It is also a variable speed switch that delivers higher speed and torque with increased
trigger pressure. Speed is controlled by the amount of switch trigger depression.
WARNING: Do not operate for long periods at low speed because excess heat
will be produced internally.
2. SWITCH LOCK
The switch trigger can be locked in the OFF position. This helps to reduce the
possibility of accidental starting when not in use. To lock the switch trigger, place the
rotation control in the center position.
3. REVERSIBLE (SEE FIG C)
For drilling and screw driving use forward rotation marked “
” (lever is moved
to the left). Only use reverse rotation marked “
” (lever is moved to the right) to
remove screws or release a jammed drill bit.
WARNING: Never change the direction of rotation when the chuck is rotating,
wait until it has stopped!
4. TWO-SPEED GEAR CONTROL (SEE FIG D)
The drill has a two-speed gear control designed for drilling or driving at LO (mark is
1) or HI (mark is 2) speeds. A slide switch is located on top of the drill to select either
LO or HI speed. When using the drill in the LO speed range, the speed will decrease
and the drill will have greater power and torque. When using the drill in the HI speed
range, the speed will increase and the drill will have less power and torque.
C
D
