12
LEAK TEST
Before lighting the appliance, a thorough leak test must be completed using a non-
ammonia soapy water solution (50% non-ammonia soap and 50% water). This is to be
applied with a small brush to all gas joints (see FIG.7) after the cylinder valve is opened no
more than 1/2 turn. If bubbles are seen, indicating a leak, turn off the cylinder and tighten
the leaking connection until a further leak test shows no leaks.
If tightening the connection does not stop the leak, call 1-888-326-8502, for assistance.
NEVER USE HOSE/REGULATOR ASSEMBLY IF LEAKING.
BEFORE YOU LIGHT THE BURNERS
Open propane gas tank valve first, then start the ON/OFF valve, lastly adjust regulators.
Once it’s done, you can light the burners.
Remember to operate ON/OFF valve and regulators per directions. “OPEN” side on
regulator will increase the flame, “CLOSE” side on regulator decrease the flame.joh
To extinguish the flame, turn off the valve on tank first, then close ON/OFF valve and
regulator.
FIG. 7
Regulator
ON/OFF Valve
