GUDEL FlexxPump4 N, Руководство по эксплуатации

Страница: 107 / 177

7.3.2.2 Checking the lubrication system
Start
End
Clean the rails and racks
Lubricate rails and racks with lubricating spray
(material number 10406825)
Remove all lubrication lines from the lubricant pump
Start the lubricant pump's lubrication cycle
Does lubricant flow
out at all hydraulic
outputs of the lubricant
pump?
Mount all lubrication lines on the hydraulic outputs of
the lubricant pump
Fill lubrication line with
lubricant. Remove air in
lubrication line. Remove kinks
Start the lubricant pump's lubrication cycle
Expose lubrication point Remount lubrication point
Yes
No
Is the lubrication line
filled without air
bubbles and kinks?
Yes
No
Check voltage supply and
function of the lubricant pump
and correct if necessary
Replace lubricating element /
lubricating pinion if necessary,
then pre-lubricate
Lubricating element /
lubricating pinion
saturated with
lubricant and intact?
Yes
No
Does lubricant flow
out at lubrication
point?
Yes
No
Other lubrication
points available?
Yes
No
Start lubrication point check I
II
III
IV
VI
V
VII
VIII
IX
X
XI
XII
• After cleaning work or during standstill times of 1 to 4 weeks, check the lubricant film on the rails and racks (II) and the lubrication lines for air bubbles and kinks (VII) before commissioning. If nec-
essary, carry out a check of the complete lubrication system.
• As operator, check the lubrication system during initial commissioning, after standstill times of more than 4 weeks, if lubricant film is not present, and after the lubricant cartridge or the lubricant
pump of the lubrication system has been replaced.
The operator is always responsible for adequate and properly functioning lubrication.
Maintenance OPERATING MANUAL FlexxPump4 N Lubrication System
3422906891_v1.0_
EN-US
107