•
Use only perfect saw discs. I.e. sharpened, without any cracks, fissures, deformations etc. Faulty discs have to be replaced
immediately.
•
Be particular about the arrow on the disc pointing on the same direction as that on the unit. .
•
The unit protection devices may never be removed or removed from operation in any way.
•
Damaged or faulty protection devices must be replaced immediately.
•
If you are disturbed by anybody when working with the saw, always finish the work you are doing before taking a look elsewhere.
•
Your work should always be placed on the bench. Never use the unit when the piece to be cut is outside the bench.
•
Be particular about your hands safely laid in a way that if slipping down, they will never come in contact with the saw.
•
If working with a long piece, use additional supports or an underlay for the saw not to get stuck. .
•
The part of work to be cut off must be free from nails and other foreign object. Always stand aside to the saw disc.
•
Do not overload the unit, it will run slower and will overheat.
•
Never cut several pieces at a time.
•
Always use the sliding guide rod.
•
Do not attempt remove free chips, pieces of wood or a jammed work from the saw without switching it off and unplugging.
•
It is necessary to switch the unit off and unplug first, if work is to be taken out of defects eliminated.
•
Adjustment, measurement , cleaning etc. may be done with the motor switched off and the unit unplugged..
•
Never leave your workplace unattended without the motor switched off and the unit unplugged.
•
When the maintenance and repairs of the safety and protection devices is completed, they have to be replaced as appropriate.
•
It is unconditional to know all the safety regulations in effect in the place of use and all the other safety regulations of general
recognition.
•
When the unit is used in closed rooms, the use is allowed in combination with a suitable exhaust system only.
•
This bench circular saw has to be connected to the mains of 230 V and 10 A as a minimum.
•
Use the supply cable of the unit for the assigned purpose only.
•
Keep a safe posture and good balance when working.
•
Before using the unit, it is essential to check on safety devices. Make sure that the parts apparently slightly damaged operate
correctly.
•
Check on every moving part and it perfect operation. Especially, be particular about any damage and . sticking parts. All the
parts have to be fitted as appropriate and to meet the conditions of their perfect operation.
•
Unless otherwise stated herein, the damaged parts and safety devices have to be replaced or repaired at an authorised servicing
centre.
•
Have the damaged switches replaced at an authorised servicing centre. .
•
The unit meets all the safety regulations. Repairs may be done by a qualified electrician at an authorised servicing centre and
only genuine spare parts must be used only. A risk of accidents arises of this is not observed.
•
Grooves, undercuts etc. should not be done with the unit, unless with a suitable protection above the bench (closed around) .
•
The saw should not be used for impact works (spliced slots etc.)
Operation
Unplug the unit before every readjustment of the saw
.
Parallel Stop
Fig. 7
•
For cutting wood lengthwise, parallel
stop (Fig. 2/pos. 3) must be used .
•
The stop may be used on either side of
the bench.
•
Lift the clamping lever (Fig. 2/pos. 6)
and shift the parallel stop (Fig. 2/pos.
3) to the required position .
•
Retighten the clamping lever (Fig.
2/pos. 6).
Caution: Do not move the stop too
far in the direction of the saw disc! The
distance between the stop and the disc must
be 20 mm at least.
25
