Troubles-Causes- Troubleshooting
Caution: Always check on overheating protection first!
The paint beam is intermittent or spasmodic.
1.
Too little paint in the can.
2.
The gun held aslant.
3.
The part with paint blocked.
4.
Loosened/damaged nozzle
5. Viscosity
too
high.
6.
Jammed hole in the lid.
Needle sealing or centre core worn.
Spray application partial only.
1.
Contaminated or damaged airhead.
2.
The paint sticks to the nozzle or damaged parts.
Uneven spray application and drops formation.
1. Damaged
nozzle
2.
Working pressure too low.
3.
Viscosity
too
high.
Uneven building of material.
1.
Working pressure too high
2.
Air head and/or nozzle jammed with paint
Inspections and servicing
After being used, the spray gun must always be cleaned
thoroughly. Pour in undiluted solvent to the container and
spray with the gun on the cloth or absorbent surface until
there is no more remaining paint in the solvent. Clean the gun
from the outside with a cloth soaked in the solvent. Before
cleaning the gun thoroughly, fully unscrew
the paint control
lock nut (4)
while looking out for the spring. Then, pull out the
nozzle needle, unscrew
the front ring (11)
and remove the
nozzle (10)
punched head. Unscrew the nozzle using the
spanner. Put all the components to a container with undiluted
solvent for a few hours. Dry out the components thoroughly
and refit the gun.
In doing so, proceed in the reverse order than when
dismantling.
Inspections and Maintenance Safety Instructions
Only a unit maintained and cared for regularly may be a
satisfactory aid. Lack of maintenance and care may result in
unforeseen accidents and injuries
.
EU – DECLARATION OF COMPLIANCE
We, GmbH & Co. KG Birkichstraße 6,
74549 Wolpertshausen, Germany
herewith declare that the following appliance complies with the
appropriate basic safety and health requirements of the EU Directives
based on its design and type, as brought into circulation by us.
In case of alternation of the machine, not agreed upon by us,
this declaration will lose its validity.
Machine description:
Profi M
Article No.:
02750
Date/authorised signature
: 12.12.2011
Title of signatory: Hr. Arnold, Geschäftsführer
Technical documentation:
J. Bürkle FBL; QS
Applicable EU Directives:
2006/42/EG
Содержание Profi M 02750
Страница 2: ...3...
Страница 39: ...M 3 1 2 3 4 5 6 7 8 9 10 11 DIN 13164 1 2 3 4...
Страница 40: ...16 2 4 141 100 0 8 1 4 0 5 x x v 110 x 60 x 250 EAN 4015671 02750 4 02750 3 3 5...
