5
Expert Net Control 2312
Device Description
Device Description
1
Security Advice
1.1
·
The device must be installed only by qualified personnel according to the following installation and
operating instructions.
·
The manufacturer does not accept responsibility in case of improper use of the device and particu-
larly any use of equipment that may cause personal injury or material damage.
·
The device contains no user-maintenable parts. All maintenance has to be performed by factory
trained service personnel.
·
The device may only be connected by a low voltage power supply (12V - 24V AC or DC) .
·
The device is intended for indoor use only. Do NOT install them in an area where excessive moi-
sture or heat is present.
·
Because of safety and approval issues it is not allowed to modify the device without our permission.
·
Please note the safety advises and manuals of connected devices, too.
·
The device is NOT a toy. It has to be used or stored out or range of children.
·
Care about packaging material. Plastics has to be stored out of range of children. Please recycle
the packaging materials.
·
In case of further questions, about installation, operation or usage of the device, which are not clear
after reading the manual, please do not hesitate to ask our support team.
Content of Delivery
1.2
The package includes:
·
Expert Net Control 2312
·
CD-ROM and manual
Description
1.3
The Expert Net Control 2312 is a multipurpose device that is suitable for switching and monitoring of
voltages. It has the following features:
·
Suitable for top hat rail mounting
·
2312: 3 switchable, potential-free relay outputs with 230V (AC 16A) switching voltage
·
Measurement of current, voltage, phase angle, power factor, frequency, active power, apparent
power and reactive power per output
·
Two energy counter for each output, one counter counts continuously, the other counter is resetta-
ble
·
Easy to read LED display to show the total current, IP-address, sensor values and error messages
·
All outputs can be switched individually on the device via HTTP, via command line tool or via serial
interface
·
Switching state and delay (0 ... 9999 seconds) adjustable for each output after power failure
·
Simultaneous switching of multiple outputs is prevented by automatic latency of 1 second
·
1 or 3-channel watchdog to monitor the connected devices (ICMP/TCP)
·
States of the relay outputs are displayed with bicolored LEDs on the front page
·
Connection for an external sensor
·
Programmable on / off sequence
·
Possible firmware update in operation via Ethernet
