Gude 370/36 LI-ION, Руководство по эксплуатации

Страница: 13 / 82

Use as designated
The battery-powered lawn mower has been designed to
treat grass areas and lawns for private purposes.
The machine cannot be used for works other than for
which it has been designed and that are specified in the
Operating Instructions.
Any other use is a use in conflict with the designation. The
manufacturer will not be liable for any consequential
damage and injuries. Please be sure to know that the
machine has not been designed for industrial purposes.
Assembly
Fitting the handles (pic. 2-3)
Caution! The cable may get damaged when assembling or
tilting the handle.
1. Tilt the handles out while paying attention to the
cable.
2. Now screw on the bottom part of the handle
using the locking wheel (pic. A/11).
3. Fixate the upper part of the handle with the
bottom part of the handle using the quick
release lever. (pic. 3)
Battery charging (pic. 4-7)
Caution! Charger to be used in dry rooms only.
General instructions for charging
To reach as long battery life as possible, the following
instructions must be followed:
•
The battery must be charged to the full extent
before being used for the first time
•
The mower is automatically switched off when
the battery voltage is low. In such a case, the
battery must be charged.
•
The battery should be charged before longer
breaks, e.g. before winterising.
•
The battery may be charged in any state of
charging and charging may be interrupted at any
moment without this causing any damage to the
battery.
1. Take out the start key.
2. Use your finger to push the battery cover and
release it.
3. Take the battery out of the compartment.
4. Connect the battery to the charger.
5. Plug the charger (230V~).
Instructions for Charger
Red LED permanently on:
Ready for operation
Greed LED flashing:
Battery being charged.
Green LED permanently on:
Charging completed.
Red LED flashing slowly:
Battery is overheated
Red LED flashing quickly:
Battery unable to be charged
Instructions to the battery charge indicator (pic. 16)
If the button on the battery is kept pressed, the charge
level can be read (pic. 16):
•
3 green LED are on: Battery is fully charged.
•
2 green LED are on: Battery is half full.
1 green LED is on: Battery is almost empty.
Caution: The battery reaches the maximum
capacity after 3-4 charges.
Mounting the collection box (pic. 8)
Fit the collection box as shown in the picture.
Operation
Caution! Rotating blade
Works/adjustments on the machine only to be performed
when the engine is off, start key removed and the cutting
blade idle.
The duration of work with a charged battery depends on
the cut grass.
The higher and thicker the grass, the shorter time you
work with a charged battery.
General information on the operation
Start key
Caution! Rotating blade
Before any adjustment:
•
Take out the start key
•
Do not touch the rotating blade
The mower may only be started when the start key is
inserted in the machine.
Hanging the collection box (pic. 9)
Fit the collection box as shown in picture 9.
Cutting height adjustment (pic. 10)
Adjust the required cutting height as shown in picture 10.
SWITCHING the mower ON/OFF (pic. 15)
Switch the mower on on a flat surface. Do not switch it on
in high grass. The mower to be tilted in high grass only if
necessary.
Switching on the engine:
•
Press the ON button (pic. 15/a)
•
With the ON button pressed, pull the safety
handle (pic. 15/b).
•
Release the ON button (Abb15/a).
Switching off the engine:
•
Release the safety handle (pic. 1/2).
Emptying the collection box
The filling indicator flap goes down when the collection box
is full.
Caution! Rotating blade
Works/adjustments on the machine only to be performed
when the engine is off, spanner pulled out and the cutting
blade idle.
•
Unhook and empty the collection box.
•
Remove any obstruction in the cutting area.
•
Refit the collection box as shown in picture 9.
•
At regular intervals, clean the openings below
the filling indicator in the collection box.
13