GB
10
The best trimming performance is reached when the hedge trimmer is guided under cutting angle of cca
15° to the hedge. (Fig. 5)
The trimmer blades run are of dual action type and enable trimming in both directions. (Fig. 6)
To get regular hedge height we recommend to tighten guiding string along the hedge. Trim away the
overhang branches. (Fig. 7)
Hooped motions from below upwards trim the hedge sides best. (Fig. 8)
6
Operation
Apart from hedges it is also possible to use the hedge trimmer for trimming of bushes and decorative
shrubbery.
6.1
Putting into operation of the Hedge Trimmer GHS 510 G
Fig. 9
Cord strain reliever
To prevent unintentional pulling the cord plug from socket be
sure the cord is properly attached to the tension strain reliever
device.
All electric service cables as e.g. extension cable, have to
be of type approved for outdoor use (splash-proof).
Fig. 10
Hedge Trimmer Güde is equipped by two-handed safety switch.
It works only when push-button located on the guiding grip is
pressed by one hand (Fig. 6) and at the same time the handle
switch is pressed (Fig. 4).
6.2
Step-by-Step Instructions
Remove foreign subjects from the trimming area before start.
Wear adequate protective clothing.
Switch on the machine according to instructions from the „Operation“ chapter.
Respect all the relevant safety instructions and advance according to the "Procedure" chapter.
Clean the machine after every use and check the trimmer blade for damages.
