Guav Crossfire 280 Series, Инструкция по эксплуатации, Страница: 6 / 10

6
4 AA 5# batteries
7
.
Binding
PRESS the Binding button
LED lighting solid.
8
.
ARMED
1. With the transmitter and quadcopter powered off, connect the battery to the CROSSFIRE again..
2.P
ress the Binding button of 350X quadcopter, then connect the flight battery, Wait until the Red LED on the quadcopter flashes rapidly,
signaling the quadcopter is initialized and start to binding.
3.I t indicates the binding successfully when the LED of receiver lighting solid.
The transmitter is bound to the model at the factory. If for any reason the model needs to be re-bound, follow the directions below.
Transmitter battery
：
4 AA 5# batteries ,or optional Nicd or Nimh 1.5 volt AA recharge batteries.
F
irstly to install the batter y(should well power) of transmitter, then power on the transmitter, next connect the flight batter y to the
CROSSFIRE, now star t the ARM process according to the following Figs.
9.DISARM the main flight controller system
The 4 pieces of Motor start to spinning after armed the main flight controller.
Mode 2
Mode 2
Mode 1
Mode 1
Pulling the rudder sticks to the bottom inside corner
。
Pulling the rudder sticks to the bottom inside corner
,
and put the
throttle stick to the bottom.
。
Pulling the rudder sticks to the bottom inside corner ,
and put the
throttle stick to the bottom.
。
Pulling the rudder sticks to the bottom outside corner
。
Please Disarm the main flight controller after landing, then the motors will stop to spinning, the Disarm process as below pictures
shown.
the main flight controller system