10
Customer Care Center 1-800-732-2677
To Insert and Remove the Batteries
Note: Do not install the batteries while the Bark
Control Collar is on your dog.
1. Loosen or remove the collar from the
Ultrasonic Bark unit.
2. Remove the screw from the back of the unit
using a small Phillips screwdriver (
A).
3. Slide the battery tray out (
B).
4. Install two (2), 3-volt (CR2032) batteries
positive (+) side up (
C).
5. Slide the battery tray back in place (
D) and secure
with the screw on the back of the unit (
E).
To Verify the Batteries are Inserted
Correctly
1. Slide the On/Off Switch to ON ( | ).
2. The LED should flash green once.
3. If the LED doesn’t flash, you may have
inserted the batteries backwards. Try taking them out and turning them over, ensuring
that the (+) side is up.
4. If the LED still does not flash, contact the Customer Care Center.
Replacement batteries (3-volt, CR2032) can be found at many retailers. Contact the Customer
Care Center or visit our website at www.guardianpet.net for a list of common retailers.
C
A
E
D
B