4.
O-rings and sliders:
Guardian provides
(2) 2½” O-rings that should be applied
to the cable lifeline to allow compatible
attachment of snap hooks and other
connecting devices.
O-rings and sliders must be attached to the
lifeline before the system is complete.
For systems with multiple intermediate
anchor points or for any other questions,
contact Guardian Fall Protection.
Table 1
Clip Size
(in.)
Rope Size
(in.)
Minimum
# of Clips
Amount of
Rope to Turn
Back (in.)
Torque
(ft. lbs.)
3/16
1/4
5/16
3/8
7/16
1/2
9/16
5/8
3/4
7/8
1
1
1/8
1¼
1
3/8
1½
3/16
1/4
5/16
3/8
7/16
1/2
9/16
5/8
3/4
7/8
1
1
1/8
1¼
1
3/8
1½
2
2
2
2
2
3
3
3
3
4
5
5
6
6
7
4
4
5
5¼
6½
11
12¾
13½
16
26
37
41
55
62
78
30
30
30
45
65
65
130
130
225
225
225
360
360
500
500
If greater number of clips than shown are used, amount of turn-back should be increased proportionately.
Torque values shown are based upon the threads being clean, dry, and free of lubrication.
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
9
Maintenance, Cleaning, and Storage
If Metal Energy Absorber fails inspection in any way, immediately remove it from service, and contact
Guardian to inquire about its return or repair.
Cleaning after use is important for maintaining the safety and longevity of Metal Energy Absorber. Remove
all dirt, corrosives, and contaminants from Metal Energy Absorber before and after each use. If Metal Energy
Absorber cannot be cleaned with plain water, use mild soap and water, then rinse and wipe dry. NEVER clean
Metal Energy Absorber with corrosive substances.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals,
or other degrading elements.
Prior to EACH use, inspect Metal Energy Absorber for deficiencies, including, but not limited to, corrosion,
deformation, pits, burrs, rough surfaces, sharp edges, cracking, rust, paint buildup, excessive heating,
alteration, and missing or illegible labels. IMMEDIATELY remove Metal Energy Absorber from service if defects
or damage are found, or if exposed to forces of Fall Arrest.
Ensure that applicable work area is free of all damage, including, but not limited to, debris, rot, rust, decay,
cracking, and hazardous materials. Ensure that selected work area will support the application-specific
minimum loads set forth in this instruction manual. Work area MUST be stable.
At least every 12 months, a Competent Person other than the user must inspect Metal Energy Absorber.
Competent Person inspections MUST be recorded in inspection log in instruction manual and on
equipment inspection grid label. The Competent Person must sign their initials in the box
corresponding to the month and year the inspection took place.
During inspection, consider all applications and hazards Metal Energy Absorber has been subjected to.
Inspection
