Installation and Use
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
4
Prior to Installation:
1. All PFAS equipment must be selected and deemed compatible with the Window Gap Anchor by a
Competent Person.
2. Installation location must meet minimum required load ratings, and must be free of any and all deficiencies,
including, but not limited to, corrosion, rust, deformation, cracking, debris, and loose materials that may
infringe upon the stability of the Window Gap Anchor.
3. Consider and minimize all existing and potential swing fall hazards.
4. ONLY for horizontal installations. NEVER install vertically. Window Gap Anchor MUST be installed in a manner
where it is supported by the floor or windowsill.
5. Window Gap Anchor adjusts to fit frames between 24” - 48” wide.
6. Window Gap Anchor is rated for loading in any direction provided it is installed as prescribed. Do not use
in horizontal lifeline (HLL) applications.
Installation:
1. Remove Clevis Pin from Telescoping Bar, adjust Window Gap Anchor to fit into frame, and reinsert Clevis Pin
into closest possible Adjustment Hole. Anchor Pads must sit fully flush with each side of frame.
2. Window Gap Anchor D-ring MUST face towards intended work area.
3. Use Fine Adjustment Screw to secure Window Gap Anchor against frame. Tighten Fine Adjustment Screw
until snug. Do not use fasteners to attach Window Gap Anchor to frame.
4. If applicable, attach SRL Attachment Accessory (part # 00380)
according to manufacturer’s instructions.
5. Attach complete and compatible PFAS to Window Gap Anchor
D-ring OR to SRL Attachment Accessory. MAXIMUM 1 connection
per Window Gap Anchor. NEVER connect simultaneously to
Window Gap Anchor D-ring and SRL Attachment Accessory.
Components and Specifications
Materials: powder-coated steel and stainless steel.
D-ring
SRL Attachment Accessory
Connection Point
Telescoping Bar
Adjustment
Holes
Fine Adjustment
Screw
Anchor Pad
Anchor Pad
# 00380
(sold separately)
