G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
5
Maintenance, Cleaning, and Storage
If Cable Ladder System fails inspection in any way, immediately remove it from service, and contact Guardian
to inquire about its return or repair.
Cleaning after use is important for maintaining the safety and longevity of Cable Ladder System. Remove all
dirt, corrosives, and contaminants from Cable Ladder System before and after each use. If Cable Ladder System
cannot be cleaned with plain water, use mild soap and water, then rinse and wipe dry. NEVER clean Cable
Ladder System with corrosive substances.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals,
or other degrading elements.
Prior to EACH use, inspect Cable Ladder System for deficiencies, including, but not limited to, corrosion,
deformation, pits, burrs, rough surfaces, sharp edges, cracking, rust, paint buildup, excessive heating,
alteration, fraying, bird-caging, and missing or illegible labels. IMMEDIATELY remove Cable Ladder System from
service if defects or damage are found, or if exposed to forces of fall arrest.
Ensure that applicable work area is free of all damage, including, but not limited to, debris, rot, rust, decay,
cracking, and hazardous materials. Ensure that selected work area will support the application-specific
minimum loads set forth in this instruction manual. Work area MUST be stable.
At least every 6 months, a Competent Person other than the user must inspect Cable Ladder System.
Competent Person inspections MUST be recorded in inspection log in instruction manual and on
equipment inspection grid label. The Competent Person must sign their initials in the box
corresponding to the month and year the inspection took place.
During inspection, consider all applications and hazards Cable Ladder System has been subjected to.
Inspection
3. Attach Bottom Assembly with (1) Small U-Bolt and (1) Mounting
Plate and supplied fasteners. Tighten with hand tools until snug.
NEVER over-tighten.
4. Loop the non-terminated end of cable through the eyelet, pull
tight, and terminate with supplied Cable Clamps. Ensure Eye Bolt
is at its minimum adjustment. The eye will be at its highest point
in relation to the Mounting Bracket.
5. Tighten eyelet until two spring washers are sitting flush against
each other.
6. Attach ladder to structure using supplied fasteners.
