Labels
G
uar
di
an
F
al
l P
ro
te
ct
io
n
63
05
S
. 2
31
st
St
.,
Ken
t,
W
A
9
80
32
12
3-W
AY
SE
LF
-R
ET
RA
CT
ING LIFELINE
/ R
ES
C
UE
DE
VIC
E
10974
50’; 3/16” CABLE
10981
65’; 3/16” CABLE
CUSTOM
Serial #
Mfg. Date
INSPECTION:
Inspect unit in accordance with manufacturer's
instructions and regulatory guidelines. Before use, inspect for any signs
of damage, wear, or malfunctioning components. Check lifeline
retraction by pulling out the entire length of the lifeline and allow it
to retract under light tension, lifeline should retract
completely. Pull sharply to test locking function,
brakes must engage. Before use, inspect the
condition and functions of the lifeline, condition of
fasteners, and legibility of labels. Also check for
evidence of defects, damage, or missing parts.
Check impact indicator for signs of activation.
IF INDICATOR IS RED, DO NOT USE!
The unit must be taken out of service for
recertification after arresting a fall, or if the
impact indicator shows signs of activation.
If inspection reveals an unsafe condition,
do not use. Unit must be inspected prior to
each use by an Authorized Person, and
every six months by a Competent or
Qualified Person. These inspections shall
be documented.
RECOVERY SYSTEM OPERATION:
Pull outward on the locking pin and hold.
Pull outward on the ratchet handle until it
stops. Release the pin so that it falls into the
locking position. While maintaining outward
tension on the cable, rotate the crank handle
clockwise (cw) to draw the cable into the
housing.
Note:
to engage the recovery system
it may be necessary to rotate the crank slightly.
FOR LOWERING:
Rotate crank handle in
counter clockwise (ccw) direction. If a fall has been
arrested and lowering is required, first crank in the upward
direction (cw) for one half rotation, then reverse the direction
(ccw) to begin lowering. A minimum of 75 lbs. (34kg) is required for
lowering.
J F M
A
A
J
M J
S O N D
YR
YR
YR
YR
YR
Date of first use
_____/_____
WARNING!
Manufacturer's instructions supplied with this product at
time of shipment must be followed for proper use, maintenance and
inspection. Alterations or misuse of this product or failure to follow the
instructions may result in serious injury or death.
DO NOT
ATTEMPT TO SELF SERVICE OR REPAIR!
USE:
Always use in accordance with manufacturer's
instruction manual and labels included with this
device at the time of shipment. This device is only
for use by one person as a fall arrester. Always
connect the snap hook directly to the dorsal
D-ring on the harness. Guard against
swing-falls by keeping the lifeline vertically
overhead. Never work above the device.
Allow 54 inches of deceleration before
lock-up. Do not allow the lifeline to
become slack, and maintain tension while
letting it retract after disconnecting from
worker. Do not allow lifeline to come in
contact with anything that will damage it
including but not limited to sharp edges,
rough or high temperature surfaces,
welding, heat sources, chemicals,
electrical hazards, or moving machinery.
Ensure connection to the anchorage is
secured properly before use. This unit is for
use by Authorized Persons only. See user
manual for more details.
SPECIFICATIONS:
Average lock speed: 4.5 ft./sec.
Maximum arrest distance: 54 inches
Average arrest force: 900 lbs.
Capacity Range: 130-310 lbs.
90151 (Rev. C)
MADE IN U.S.A.
Meets or exceeds:
OSHA 1926.502, OSHA 1910.66
ANSI Z359.1-07
MADE IN U.S.A.
Meets or exceeds:
OSHA 1926.502, OSHA 1910.66
ANSI Z359.1-07
3-WAY SELF-RETRACTING LIFELINE /
RESCUE DEVICE
Содержание 10974
Страница 2: ......
