Guardian Fall Protection 10974, Инструкция по эксплуатации

Страница: 13 / 15

Installation and Use
G
uar
di
an
F
al
l P
ro
te
ct
io
n
63
05
S
. 2
31
st
St
.,
Ken
t,
W
A
9
80
32
11
1. With compatible carabiner, attach 3-Way SRL to anchor point at or above harness dorsal
D-ring, OR attach to compatible tripod with Mounting Bracket part #10983.
2. If being used in combination with Arc-O-Pod or other compatible tripod, completely assemble,
install, and use tripod according to manufacturer’s instructions provided with tripod at time of
shipment. TRIPOD MUST HAVE INTEGRAL PULLEY.
3. If being used in combination with tripod, install Mounting Bracket on tripod leg. 1) Place
Mounting Bracket over leg as shown, so 3-Way SRL snap hook will face up towards tripod pulley;
2) Select desired height of 3-Way SRL on tripod leg, and place Mounting Bracket at selected
location; 3) Install (2) provided Locking Pins through Mounting Bracket and tripod leg as shown;
4) Secure Locking Pins with connected hitch pins, and ensure Mounting Bracket is fully secured
to tripod leg.
4. Install 3-Way SRL on Mounting Bracket as indicated below.
Locking Pins
inserted through
Mounting Bracket
and tripod leg,
and secured
with hitch pins.
3-Way SRL
Swivel Eye
attached to
install location
on Mounting
Bracket.
Shoulder Bolt
inserted through
Mounting Bracket
and 3-Way SRL,
and secured with
hitch pin.
5. To switch 3-Way SRL to rescue/retrieval mode, pull and
hold Winch Locking Pin, then move handle back and forth
until Plunger Pin releases out, and release Winch Locking Pin.
6. To switch 3-Way SRL to standard SRL mode, pull and hold
Winch Locking Pin, then compress Plunger Pin, and release
Winch Locking Pin. Ensure Plunger Pin remains down and
locked in place.
7. To lower cable, rotate Winch Handle counter-clockwise.
To raise cable, rotate Winch Handle clockwise.
8. RESCUE/RETRIEVAL MODE FOR EMERGENCY USE ONLY. DO NOT USE 3-WAY SRL FOR ROUTINE
HOISTING OF PERSONNEL OR MATERIALS.
Pull Winch
Locking Pin
Plunger Pin