1.
1.
Completely unthread top thumb screw. Remove
pivot post washer and indicator. Remove pivot post
from cutter block.
2.
2.
Slide pivot post washer onto pivot post.
Reinsert pivot post with washer into bottom of
cutter block. Be sure flat side of pivot post block
faces cutting blade. Replace indicator. Rethread
top thumb screw.
3.
3.
To cut a desired width, set indicator to
double the width plus 3/16” (5 mm). For
example, to cut 1” (25 mm) width, set indicator
to 2-3/16” (55 mm).
CUT STRAIGHT STRIPS
4.
4.
Loosen cutting blade thumb screw on cutter
block. Position cutting blade to protrude slightly
beyond thickness of gasket material. Tighten
thumb screw.
5.
5.
Place gasket material on cutting board. Align
edge of gasket material with cutting board. Press
down on gasket material. With slight downward
pressure, run cutting block along edge of cutting
board using flat side of pivot post block as a guide.
For thicker gasket materials, use edge of gasket
material itself as a guide.
www.allpaxcorp.com
(continued on next page)
