8
1. Manual-mode: Call up scanners manually
To select the manual mode, press Auto / Del button until Manual LED is lit.
In Manual-mode (Program-LED off ), you can call up the connected scanners manually and control
them via the channel faders. Please note that adjusted settings cannot be memorized.
Select the desired scanner via the respective scanner select button. Adjust the desired function via
the channel faders.
Check a Bank / Scene
Select the bank you want to check via bank buttons. Select the scene you want to check via one of
the scene buttons.
Check a Chaser
Select the chaser you want to check via the chaser buttons. Press Tap / Display button, the display
will show the steps in the chaser. Press Bank buttons to see each scene.
Page Select-button: Via the Page Select-button, you can adjust the channel faders from CH 1-8
(Page A Led lit) to CH 9-16 (Page B LED lit) or both of them (Page A and B LED lit together).
Display-button: Via the Display-button, you can switch the display of the faderway from DMX-
value (0-255) to percent (0-100%).
2. Programming
A program (bank) is a sequence of different scenes (steps) that will be called up one after another.
With this DMX Operator, you can program up to 30 different programs (banks) with up to 8 scenes
(steps) each.
2.1. Programming a program
Press and hold the Program-button for about 2 seconds to enter the programming mode. The
Program-LED will flash in display.
Select the desired scanner via the scanner select buttons.
Adjust the desired settings (the value will be shown in the display) via the respective channel faders.
Press Midi / Rec button to prepare saving.
Select the desired program (bank 01 - 30) you will save via the Bank-buttons.
Press one of the Scene-buttons in order to save the data. All LEDs on the panel will be flashing
indicating the data is saved.
Select the next scanner via the scanner select buttons and repeat the steps Above until the program
is finished or the maximum number of steps - 8 - has been reached.
Press and hold the Program-button in order to exit programming mode.
