5
30. MIDI INPUT SOCKET
31. DMX POLARITY SELECTOR
32. DMX OUTPUT SOCKET
33. DMX INPUT SOCKET
34. FOG MACHINE SOCKET
35. DC INPUT SOCKET
36. POWER ON / OFF SWITCH
SETUP
SETUP
SETUP
SETUP
1. Installation
Install the device on a plane surface or install it in a rack.
Rack-installation: This device is built for 19" rack (483 mm). The rack you use should be a double-
door-rack where you can open the front panel and the rear panel. The rack should be provided with
a cooling fan. When mounting the device into the rack, please make sure that there is enough space
around the device so that the hot air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into
your outlet.
2. Sound-control
The sound-control works via built-in microphone or via the Line In socket. Connect the sound-
signal from the mixer (e.g. Master 2) with the RCA-socket on the rear panel ( input sensitivity 0.1
V - 1 V).
3. DMX 512 Connection with the projectors
The wires must not come into co ntact with e ach
oth er, otherwise the f ixtu re s will not work at a ll,
or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the
controller with the fixture or one fixture with another.
Occupation
Occupation
Occupation
Occupation of
of
of
of the
the
the
the XLR-connection:
XLR-connection:
XLR-connection:
XLR-connection:
You can adjust the XLR polarity via the DMX POLARITY selector.
