3
Installing lights on top of the gate post:
1. Insert small screws into holes on the underside of lens
hood as shown in
Figure 7
. Only screw them part way
so they can twist lock into place on top of lens.
2. Install wires into the light bulb socket by simply press-
ing a brass connector into each side of the socket until it
snaps into place. See
Figure8
.
3. Line up the slots on the socket with the notches in the
lens. Insert the scoket into the lens. Firmly grasp the
socket, push and twist until it snaps into place as shown
in
Figure 9
.
4. Assemble the rest of the light using the angled lens sup-
port as shown in
Figure 10
. Do not glue any of the parts
at this time.
Use small
amount of glue
to secure lens
support as-
sembly
Figure 12
Figure 11
Figure
Lens Hood
Lens
4 Watt Light
Light Socket
Lens Support
Wire Nuts
Mounting Plate
Low Voltage Wire
(RB509)
5. Determine where the low voltage wire will be run. Con-
nect to the lights using the wire nuts provided before
mounting the fi xtures. The notches in the mounting plates
are openings for running the low voltage wire. Be sure it
is facing the direction the wire will enter.
6. Use the self tapping screws provided to attach the assem-
bled fi xtures to the gate posts. Additional hardware my
be required depending on the type of gate posts you have.
See
Figure 11
.
7. When you are satisfi ed with the placement of the fi xtures,
glue the lens support pieces using a small amount of glue
(provided). Be careful to keep the glue off the outside of
the support pieces. See
Figure12
.
Figure 7
Figure 8
Figure 9
