14 -
The RED/BROWN, YELLOW/BROWN, RED/GREY and YELLOW/GREY wires must be
connected to the original vehicle central door locking system as indicated on the vehicles
installation guides supplied by GT, or following the section DESCRIPTION OF THE ALARM
SYSTEM ARMING/DISARMING COMMAND WIRES (Page 8).
15 -
Connect the GREEN/YELLOW wire to O/E vehicle earth to carry out the DOORS LOCK/
UNLOCK SIGNALS SELF-CODING procedure and to carry out the RAPID TEST (page 8-9).
16 -
If you want to activate the ANTI-HIJACK FUNCTION connect the BLACK /WHITE wire to
the supplied N/O switch, connect the other side of the switch to earth.(refer to GENERAL
CONNECTION DIAGRAM page 5). Mount the button in a position not visible but easily
reachable.
17 -
ULTRASONIC SENSOR: Install the two ultrasonic transducers at the top of the “A”
pillars, one to the right and one to the left (see picture) pointing towards a hypothetical point
at the centre of the rear window and ensure that between the ultrasonic transducers and the
rear window there are no objects (i.e. headrest, etc.).
Plug the ultrasonic tranducers in the suitable alarm connectors paying attention to their colours
(refer to GENERAL CONNECTION DIAGRAM page
5). To adjust the sensitivity of the ultrasonic sensor,
turn the adjuster close to the main alarm connector
clockwise to increase and anti clockwise to decrease.
Do not cut or lengthen the ultrasonic transducers
cables.
WARNING:
- When the installation has been completed, reconnect the O/E vehicle earth and
carry out the alarm system SET FUNCTIONS.
RED
ADJUSTMENT
WHITE
4
