D-9105RExd
Digital Flame Proof Reflective Beam Detector
Installation and Operation Manual
The Intelligent Solution
15
3.
Fault test
Cover the receiving or transmitting window of the detector quickly with
the IR Light Filter to obscure the optical pathway. Yello w LED of the
detector should be turned on. Taking off the filter immediately, yellow
LED of the detector should be turned off.
4.
Defect Detectors
For detectors failing in testing, please repair them following the
instructions in the sections of
Troubleshooting
and
Maintenance
, and
re-test them. If they fail again, return them to factory for repair.
VII Operation
The detector address, device type and sensitivity level can be simply
programmed by P-9910B hand held programmer. Open the detector’
s
top cover, connect the ribbon cable from the detector body to XT2 of
the small connector board coming with the detector, and then connect
the I
2
C cable of hand held programmer (PS/2 cable) with XT1 of the
connector board (or directly connect the ribbon cable of the detecto r
body with the connector on the base, and the I
2
C cable to XT3 of the
interface board). Turn on the power of hand held programmer, input 2,
5, 9 and
Function
to enter I
2
C programming mode, the screen shows a
“0”
. After programming, input 2, 5, 9 and
Function
again to exit I
2
C
programming mode and return to power -on state.
1.
Reading Information
Using the hand held programmer, you can easily get original
information of the detector, such as the
address. Refer to details
below:
(1) Enter I
2
C programming mode, th e screen shows a “0”
.
(2) Press
Test
, the screen shows the address code of the detector.
(3) Press
Up
, the screen shows sensitivity level and device type in
sequence.
(4) Press
Down
, the screen shows above contents in opposite way
Содержание D-9105RExd
Страница 1: ......
