6
•
Place the clamp (B) over the holes that match
the size of the screws. There are one set of
screw holes in each corner of the cooktop.
Slightly tighten a screw (C) through the
clamp (B) so that the clamp is attached to the
cooktop, but so that you can still adjust the
position of it.
•
Carefully turn the cooktop back over and then
gently lower it into the aperture hole that you
have cut out.
•
On the underneath of the cooktop, adjust the
clamps into a position that is suitable for your
worktop. Then fully tighten the screws (C) to
secure the cooktop into position.
Installing the appliance
•
Cut a hole in the worktop that corresponds
with the drawings shown above.
•
IMPORTANT
: You must have a gap of at
least 25 mm between the underneath of the
appliance and any surface that is below it.
•
Carefully turn the cooktop upside down and
place it on a cushioned mat.
•
Apply the sealing strip provided around the
edge of the appliance.
•
The protective covering must be removed from
both sides.
•
Do not leave a gap in the sealing agent or
overlap the thickness.
•
IMPORTANT
: Do not use a silicon sealant to
seal the appliance against the aperture. This
will make it difficult to remove the hob from the
aperture in future, particularly if it needs to be
serviced.
