Page 4 of 4
Model:
NGBC1222
Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia
12 Volt
DC-DC Voltage Booster Battery Charger
Operating Instructions
Please read these instructions before use
NGBC-R3
Fig. 3 Automatic Start Assist
Follow connections for
ORANGE, BLUE & YELLOW
as per Fig.1 or Fig.2 where
applicable.
Important: If Optional Start Assist Pack is not purchased with kit then
make sure that the solenoid is capable of at least 100A.
Cabling used in the start assist bypass (
ASSIST Wire and RED
) will
need to be suitable for high current stresses for starting the vehicle.
This optional extra enables the automatic use of the energy stored in the auxiliary battery to start a vehicle with a faulty or
discharged main battery.
When using this option a high current solenoid is activated for approx. 30 seconds following an ignition attempt where the main
battery drops below 7V.
, and no auxiliary
battery charge will take place, to insure the main battery is replenished as soon as possible, until the next ignition attempt.
Temperature Compensation :
Temperature compensation of the battery charging voltage extends the battery life and improves the charging process.
Fixed charging voltage can result in either undercharging the battery at low temperatures or overcharging it at high temperatures.
of the battery operating temperature.
The NGBC1222 applies a small negative coefficent to the programmed voltage (Approx. -5mV/°C) to compensate for the variation
Attach supplied Thermal sensor to the smaller Black and Red wires (Not the Main and Auxiliary wires) and mount the sensor near
the battery to measure ambient temperatures at the charging/auxilary battery
.
(This feature is for lead based chemistries only.)
Warranty Conditions:
Our products come with guarantees that cannot be excluded under the Australian Consumer Law.
The customer is entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.
The customer is also entitled to have the products repaired or replaced if the products fail to be of acceptable quality and the failure does not amount to a major failure.
GSL Electronics (GSL) warrants that its products will, under normal use and service, be free of defects in material and workmanship for a period of two (2) years from
the date of the original purchase by the customer as marked on the customer’s original invoice.
Please refer to our website for full warranty and return information which can be found at http://www.gsl.com.au/faq.html
Automatic Start Assist:
RED
GREEN
BLACK
BROWN
ASSIST Wire
FUSE
30A
If the temperature compensation is not required then simply cut the wires to the thermal sensor to avoid abnormal charging.
