Page 2 of 2
Model:
BCAC1230RV
Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia
Fixed Connection Multi-Chemistry
Automatic Battery Chargers
Operating Instructions
Please read these instructions before use
CHARGE PROCEDURES:
1.
Remove ller caps (for unsealed batteries) from battery and check electrolyte levels in each cell. If the level is low then top up with distilled water.
2.
Connect the battery charger to the supply mains.
3.
After the mains has been connected the charger will test the battery condition, the test is indicated on the charger by way of the two
LED’s on simultaneously.
4.
Once the charger has determined the battery’s state of charge it will begin charging at the required stage necessary to bring the battery
up to capacity indicated by a single blinking LED next to the selected chemistry.
6.
When the charging is completed the LED will stop blinking and remain on.
7.
The battery can remain connected inde nitely to the charger which will alternate between charge stages for optimum long term battery maintenance.
Safety Approval:
E.M.I AS2064 GR.1 A | V071019 AS/NZS 3350.2.29
Product Speci cations
Model
BCAC1230RV
Input Voltage NOMINAL
240 VAC
Input Current MAXIMUM
5 ARMS
Bulk Charge Output [VDC±1%] GEL / AGM
14.3V
Bulk Charge Output [VDC±1%] Flooded/ CALCIUM
14.6V
Float Charge Output [VDC±1%] GEL / AGM
13.3V
Float Charge Output [VDC±1%] Flooded/ CALCIUM
13.5V
Max Output Current [ ADC±5%]
30ADC
Battery Voltage Required For Start-up
6V
Protections
Over Temperature, Over Current, Short Circuit,
Over Voltage, Bulk Charge Time-Out
Cooling
Via Fan, Load Activated
Ef ciency (Typical)
Greater than 85%
Stand By Drain On Battery
1mA
Dimensions [mm ] (L x H x W)
250mm X 65mm X 160mm
Weight [ Kg ]
2.2Kg
NOTE:
Colour coded wires are as follows : Red for (+) Positive pole and Black for (-) Negative pole.
DO NOT Attempt to Recharge Non-Rechargeable Batteries or Non Lead Acid Based Chemistries.
Changing Chemistry Battery Type: Press and Hold the “TYPE” Push Button until both LEDs turn On
and Then Reset The Charger By Disconnecting and Reconnecting The AC Power.
BCAC1230RV-R2
LED Status Table
NO LEDS ON
No AC Input, check if AC is available, if AC is available please return product for repair.
BOTH LEDS BLINKING PERMANENTLY
Battery Damaged, Check and or Replace Battery.
BOTH LEDS BLINKING DURING STARTUP
Normal, Initial Battery Condition Test.
SINGLE LED FLASHING
Normal, Selected Chemistry Under Bulk Absorption.
SINGLE LED ON
Normal, Selected Chemistry Charged.
BOTH LEDS ON
Overvolatge or Over Temperature, disconnect power for 5 minutes,
if the problem persists please return product for repair.
Warranty Conditions:
Our products come with guarantees that cannot be excluded under the Australian Consumer Law.
The customer is entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.
The customer is also entitled to have the products repaired or replaced if the products fail to be of acceptable quality and the failure does not
amount to a major failure.
GSL Electronics (GSL) warrants that its products will, under normal use and service, be free of defects in material and workmanship for a
period of two (2) years from the date of the original purchase by the customer as marked on the customer’s original invoice. Please refer to our
website for full warranty and return information which can be found at http://www.gsl.com.au/faq.html
