Page 1 of 2
Unit 2, 1 St James Place, Seven Hills ,NSW, 2147, Australia
Installation & Operating Instructions
Please read these instructions before use
The EBC range is a new generation of brake controllers
utilising microprocessor based technology. It is a compact,
rugged, all electronic brake controller and is easily installed
with the connection of four wires and the mounting bracket
supplied. Easily adjustable via the front display and
simple up, down controls. Both models also incorporate
an emergency over-ride slide lever for manual control.
Designed for both single and dual axle trailers using
negative earth (ground) systems only. Available in 12V &
the new 24V version eliminating the need for a separate
reducer on 24V systems
.
EBC-R22
Specifications
EBC-12
EBC-24
Minimum Input Voltage
9 VDC
18 VDC
Nominal Input Voltage
12 VDC
24 VDC
Maximum Input Voltage
15 VDC
30 VDC
Output Voltage
12V
12V
Suitable For 12V Trailer Brakes
Yes
Yes
No Current Load
30 mA
Maximum Load
2 Axel / 12A Avg
Dimensions
40mm x 80mm x 125mm
Weight
270gm
Models:
EBC-12 & EBC-24
ELECTRONIC BRAKE CONTROLLER
Installation :
1.
Disconnect the vehicle’s NEGATIVE battery terminal.
2.
Determine a suitable mounting location. The unit must be mounted securely to a solid surface and be easily accessible to the driver.
3.
Hold the mounting bracket in the selected position and mark the hole location through the holes in the bracket.
4.
Using a suitable drill bit, drill holes in the marked locations.
5.
Secure bracket in position with self tapping screws being careful not to strip the holes by over-tightening.
6.
Mount the brake control unit in the bracket by snapping into position.
Features :
• Digital Display For Accurate Set-Up And Ease Of Use
• Easy adjustment Via Two Push-buttons
• Open circuit & Overload Indication and protection
• Convenient Over-Ride Slide Lever
Note : The EBC-24 is load activated and can not be tested without load. At no load, output reading of 24V will register.
Pleas note that the output voltage is PULSED, so it cannot be measured with a volt meter or test light.
• Selectable Three Position Ramp-Up For Brake Speed
• 2 Axel 12A Output Capability
• Top Or bottom Mounting Via The Multi Position Bracket
• Can Be Mounted On Any Angle
Black Wire: +VDC
White Wire: 0V DC
Red Wire: Brake Switch
Blue Wire: Brake
* Please Note: An External Fuse Must Be Fitted (Not Supplied).
15A Fuse*
* The Control Unit is Activated by A Positive Feed Brake Switch Only.
(Please check the polarity of your vehicles brake switch before connection)
More information https://www.caravansplus.com.au
