Page 2 of 2
Model:
BC240-1230
BC240-2418
Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia
Dual Chemistry 4 Stage
Automatic Battery Chargers
Operating Instructions
Please read these instructions before use
Procedures for Charging a Battery:
The chargers are intended for 12V/24V lead acid and Calcium batteries with a capacity ranging from 50AH to 250AH.
DO NOT attempt to recharge non-rechargeable batteries or non lead acid based chemistries.
1.
then top up with distilled water.
2.
It is recommended to remove the battery from the vehicle or, if this is not practical, then disconnect the leads. If the
The
and are the correct polarity (+ Pos to + Pos & - Neg to - Neg).
3.
Connect the battery charger to the supply mains.
4.
has commenced.
5.
If the battery is a Calcium type then press the [MODE] switch and the [CALCIUM] led will turn on indicating the
Calcium charge mode.
6.
When the charging is completed the [CHARGE] led will stop blinking and you may then disconnect the battery.
7.
optimum long term battery maintenance.
NOTE:
Colour coded clips are as follows : Red for (+) Positive pole and Black for (-) Negative pole.
Model
BC240 - 1230
BC240 - 2418
Input Voltage [ V
AC
]
240 V
AC
240 V
AC
Input Current [ A
RMS
]
5 A
RMS
4.5 A
RMS
Bulk Charge Output [V
DC
±1%] (Pb/
Ca)
14.5V
DC
/15.5V
DC
29V
DC
/31V
DC
Float Charge Output [V
DC
±1%] (Pb/
Ca)
13.5V
DC
/14V
DC
27V
DC
/28V
DC
Max Output Current
[ A
DC
±5%] (Pb/Ca)
30V
DC
/28V
DC
18V
DC
/16V
DC
Battery Voltage required for start-up
8V
DC
16V
DC
Dimensions [ mm ] (L x H x W)
250mm X 65mm X 160mm
Weight [ Kg ]
2.2Kg
E.M.I
AS2064 GR.1 A
Safety Approval
Approval V071019, AS/NZS 3350.2.29
Protections
Over Temperature, Over Current, Short
Circuit, Over Voltage, Reverse Polarity,
Bulk Charge Time-Out
Cooling
Via Fan, Load Activated
Greater than 85%
BC1230-2418-R2
Warranty Conditions:
Our products come with guarantees that cannot be excluded under the Australian Consumer Law.
The customer is entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.
The customer is also entitled to have the products repaired or replaced if the products fail to be of acceptable quality and the failure does not
amount to a major failure.
GSL Electronics (GSL) warrants that its products will, under normal use and service, be free of defects in material and workmanship for a
period of two (2) years from the date of the original purchase by the customer as marked on the customer’s original invoice. Please refer to our
website for full warranty and return information which can be found at http://www.gsl.com.au/faq.html
